- Remote Control[9]
- Alarm[10]
- Xenon Lamps[10]
- Auto Lighting System[2]
- Car Alarms[10]
- Auto Sensors[2]
- Other Auto Parts[1]
- Speaker & Horn[1]
- Other Motorcycle Parts[4]
- Other Motorcycle Accessories[6]
- Central Locking System[6]
- Access Control System[2]
- Other Access Control Products[1]
- Car Reversing Aid[10]
- Car Windows[3]
- Contact Person : Mr. Wei Zhang
- Company Name : Zhongshan Nengtong Burglarproof Equipment Co., Ltd.
- Tel : 86-760-22278660-601
- Fax : 86-760-22270816
- Address : Guangdong,Zhongshan,Road 3, Shengfeng Yuesheng Village, Xiaolan Town, Zhongshan City, Guangdong , China
- Country/Region : China
- Zip : 528415
Bypass Module
Bypass Module
We are the manufacturer of bypass module since 1998 here in China. Here below are the manual for this item:
1. Transponder Bypass Module 2. Works on all Factory Anti-theft Systems 3. Will work with any Vehicle
A: Remove the transponder from the key (there maybe a door on the top of the key that can be opened and the transponder can be removed). Or if impossible, the entire key may be mounted inside the bypass module.
B: Pull apart the case and place the transponder, or the head of the key, inside the 10 wire loop on the circuit board. Transponders are directional and must be placed along the same direction that the key would lay ,Use the double stick foam tape provide-one layer on the circuit board and then the transponder, or key, and finally the second double-stick foam tape layer on top of it to hold key securely in place.
C: The transponder LOOP goes underneath the steering column and up toward the ignition key cylinder and needs to be positioned so that there are 2 turns around the transponder antenna ring as shown below. The transponder ring is usually a black plastic ring that goes around the outside of the ignition lock cylinder near where the key is inserted, You will need to remove the plastic cover of the steering column in order to expose it. The transponder loops need to go around the outside diameter of this ring, not in front of it or behind it. Secure the loop with electrical tape to tighten up the loops of wire and hold it in place. Plug the other end of the transponder loop into the Universal Alarm Bypass Module.
D:Now start the vehicle with the remote starter. If the vehicle starts and runs for at least 30 seconds the transponder bypass is correct. Note: if the vehicle does not start with the remote starter, try adjusting or changing the position of the transponder in the bypass module or adjusting the position of the two loop wire around the transponder pick-up antenna mentioned above.
E: Note: The key that the transponder was removed was removed from will no longer start the vehicle, but can be used to drive the vehicle after it has been started remotely.
Bypass Module